Kenwood DNX997XR Instruction Manual page 108

Connection/Installation
In case of DNX997XR
• Do not press hard on the panel surface when
installing the unit to the vehicle. Otherwise
scars, damage, or failure may result.
• Reception may drop if there are metal objects
near the Bluetooth antenna.
Ñ
Supplied accessories for
installation
1
2
[1]
3
4
5
108
Cooling fan
Bluetooth antenna unit
(Black 1 m)
(Gray 1 m)
(3 m)
6
7
8
9
0
[1]
-
DNX997XR / DNX697S only
[1]
Ñ
Installation procedure
1) To prevent a short circuit, remove the key
from the ignition and disconnect the ¤
x1
terminal of the battery.
2) Make the proper input and output wire
connections for each unit.
3) Connect the speaker wires of the wiring
x1
harness.
4) Connect the wiring harness wires in the
following order; ground, battery, ignition.
5) Connect the wiring harness connector to the
x1
unit.
6) Install the unit in your car.
7) Reconnect the ¤ terminal of the battery.
8) Perform the Initial Setup.
x1
See Initial SETUP (P.12).
x2
(M5 x 8 mm)
x6
(M5 x 8 mm)
x6
x1
(3.5 m)
x1
x1
x1