Advertisement
HDD Power Down
When enabled and after the set time of system inactivity, the hard
disk drive will be powered down while all other devices remain active.
The settings are: 1/2/3/4/5/6/7/8/9/10/11/12/13/14/15Min and Disabled.
HDD Down In Suspend
When enabled, the hard disk drive will be powered down with the
other device during suspend mode.
The settings are: Enabled and Disabled.
Soft-Off by PBTN
Pressing the power button for more than 4 seconds forces the system
to enter the Soft-Off state. The settings are: Delay 4 Sec, Instant-Off.
PWRON After PWR-Fail
This option will determine how the system will power on after a
power failure.
RI Resume/WOL
To use this function, you need a LAN add-on card which support power on
functions. It should also support the wake-up on LAN jumper (JWOL).
Enabled
Disabled
Modem Use IRQ
This determines the IRQ in which the MODEM can use.
The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
RTC Resume
This function is for setting date and time for your computer to boot
up. During Disabled, you cannot use this function. During Enabled, choose
the Date and Time Alarm:
Date(of month) Alarm
Time(hh:mm:ss) Alarm
Note: If you have change the setting, you must let the system boot up until
it goes to the operating system, before this function will work.
Wake up on LAN supported.
Wake up on LAN not supported.
You can choose which month the
system will boot up. Set to 0, to boot
every day.
You can choose what hour, minute and
second the system will boot up.
3-22
®
Advertisement
