Table of Contents
Advertisement
Standby TimeOut (Minute)
This option defines the continuous idle time before the system
enters STANDBY mode. If any item defined in the options of "Power Down
and Resume events" is enabled & active, STANDBY timer will be reloaded.
When the system has entered Standby mode, any of the items that are
enabled in "Wake Up Events of Doze and Standby" will trigger the system to
wake up. The settings are Disabled, 1 min, 2 min, 3 min, 4 min, 5 min, 6 min, 7
min, 8 min, 9 min, 10 min, 11 min, 12 min, 13 min, 14 min or 15 min. The
Optimal and Fail-Safe default settings are Disabled.
Suspend Time Out (Minute)
This option specifies the length of a period of system inactivity
while in Suspend state. When this length of time expires, the computer
enters Suspend power state. The settings are Disabled, 1 min, 2 min, 4 min, 8
min, 10 min, 20 min, 30 min, 40 min, 50 min or 60 min. The Optimal and Fail-
Safe default settings are Disabled.
Throttle Slow Clock Ratio
This option specifies the speed at which the system clock runs in
power saving states. The settings are expressed as ration between the
normal CPU clock speed and the CPU clock speed when the computer is in
the power-conserving state.
Display Activity/IRQ 3/IRQ 4/IRQ 5/IRQ 7/IRQ 9/IRQ1 0/
IRQ 11/IRQ 13/IRQ 14/IRQ 15/System Thermal
When set to Monitor, these options enable event monitoring on the
specified hardware interrupt request line. If set to Monitor and the computer
is in a power saving state, AMI
IRQ line. The computer enters the full on power state if any activity occurs.
®
AMI
BIOS reloads the Standby and Suspend timeout timers if
activity occurs on the specified IRQ line.
Thermal Slow Clock Ratio
When set to Monitor, then you can choose the throttle ratio. This
option is connected with the CPU Critical Temperature Option.
®
BIOS watches for activity on the specified
3-14
®
Advertisement
Table of Contents
