Chevrolet 2007 Cobalt Owner's Manual page 94

/
(Remote Start): If your vehicle has the remote
start feature, the RKE transmitter will have a
button with this symbol on it.
To start the vehicle using the remote start feature,
do the following:
1. Aim the transmitter at the vehicle.
2. Press and release the transmitter's lock
button, then immediately press and hold
the transmitter's remote start button until the
vehicle's turn signal lamps flash.
3. When the vehicle starts, the parking lamps
will turn on and remain on while the engine
is running.
The engine will shut off automatically after
10 minutes, unless a time extension has been
done or the vehicle's key is inserted into
the ignition switch and turned to RUN.
If you enter the vehicle after a remote start,
and the engine is still running, insert the
key into the ignition switch and turn to RUN to
drive the vehicle.
94
4. To manually shut off a remote start, do any of
the following. The parking lamps will turn off
to indicate the engine is off.
•
Aim the RKE transmitter at the vehicle and
press and release the remote start button.
•
Turn on the hazard warning flashers.
•
Turn the ignition switch to RUN and
then LOCK.
Your vehicle's engine can be started two times,
per ignition cycle, using the transmitter's remote
start feature. If only one remote start procedure
has been done, since last driving the vehicle,
or resetting the remote start system, the engine
may be started again remotely by following
the remote start procedure a second time.
If the remote start procedure is used again before
the first 10 minute time frame has ended, the
first 10 minutes will immediately expire and
the second 10 minute time frame will start.