Remote Keyless Entry System - Chevrolet 2005 Uplander Owner's Manual

®
Any new PASS-Key III key must be programmed
before it will start your vehicle. See PASS-Key
page 2-28 for more information on programming
your new key.
Notice: If you ever lock your keys in your vehicle,
you may have to damage the vehicle to get in.
Be sure you have spare keys.
If you ever do get locked out of your vehicle, see
Roadside Assistance Program on page 7-6 for more
information.
If your vehicle is equipped with the OnStar
an active subscription and you lock your keys inside
®
the vehicle, OnStar may be able to send a command to
unlock your vehicle. See OnStar
for more information.

Remote Keyless Entry System

If the vehicle has the keyless entry system, it operates
on a radio frequency subject to Federal Communications
Commission (FCC) Rules and with Industry Canada.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation of the device.
2-4
®
III on
®
system with
®
System on page 2-42
This device complies with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation of the device.
Changes or modifications to this system by other than
an authorized service facility could void authorization to
use this equipment.
At times you may notice a decrease in range. This is
normal for any remote keyless entry system. If the
transmitter does not work or if you have to stand closer
to your vehicle for the transmitter to work, try this:
•
Check the distance. You may be too far from your
vehicle. You may need to stand closer during
rainy or snowy weather.
•
Check the location. Other vehicles or objects may
be blocking the signal. Take a few steps to the
left or right, hold the transmitter higher, and
try again.
•
Check to determine if battery replacement is
necessary. See "Battery Replacement" under
Remote Keyless Entry System Operation on
page 2-5.
•
If you are still having trouble, see your dealer or a
qualified technician for service.