Chevrolet 2005 Uplander Owner's Manual page 18

Reinstalling the Bucket Seats
CAUTION:
{
A safety belt that is improperly routed, not
properly attached, or twisted will not provide
the protection needed in a crash. The person
wearing the belt could be seriously injured.
After installing the seat, always check to be
sure that the safety belts are properly routed
and attached, and are not twisted.
Do not install the seat facing the rear of the vehicle, as
it will not lock into place. If more storage room is
needed behind the seat, slide the seat forward.
Make sure the seat is in the full rear position before
beginning this procedure.
1-12
To reinstall the bucket seats, do the following:
1. With the seat folded, squeeze the angled bar
beneath the seat toward the straight crossbar, while
placing the front hooks of the seat into the front
two floor pins.
If the front hooks are not attaching correctly, check
that the seat is in the full rear position.
2. Make sure the seat is
angled so that the front
seat hooks clear the
floor pins. If the
front hooks are not
attached correctly, the
seat's rear hooks
will not attach to the
rear set of floor pins.