Checking Wiring And Connectors; Checking Propeller - Yamaha F2.5 Owner's Manual

Hide thumbs Also See for F2.5:
Table of Contents

Advertisement

TIP:
If a torque wrench is not available when you
are installing the drain screw, finger tighten
the screw just until the gasket comes into con-
tact with the surface of the drain hole. Then
tighten 1/4 to 1/2 turn more. Tighten the drain
screw to the correct torque with a torque
wrench as soon as possible.
4.
Add the correct amount of oil through the
filler hole. Install the filler cap. NOTICE:
Overfilling the oil could cause leakage
or damage. If the oil level is above the
upper level mark, drain until the level
meets the specified capacity.
Recommended engine oil:
4-stroke outboard motor oil
Engine oil quantity:
0.4 L (0.42 US qt, 0.35 Imp.qt)
1. Oil filler cap
5.
Start the engine and watch to make sure
the low oil pressure-alert indicator (if
equipped) turns off. Make sure that there
are no oil leaks. NOTICE: If the low oil
pressure-alert indicator does not turn
off or if there are oil leaks, stop the en-
gine and find the cause. Continued
operation with a problem could cause
severe engine damage. Consult your
Yamaha dealer if the problem cannot
be located and corrected.
6.
[ECM01850]
7.
TIP:
For more information on the disposal of
G
used oil, consult your Yamaha dealer.
Change the oil more often when operating
G
the engine under adverse conditions such
as extended trolling.
EMU29112

Checking wiring and connectors

Check that each grounding wire is properly
G
secured.
Check that each connector is engaged se-
G
curely.
EMU32111

Checking propeller

EWM01880
You could be seriously injured if the en-
gine accidentally starts when you are near
the propeller.
Before inspecting, removing, or install-
G
ing the propeller, place the shift control
in neutral, turn the main switch to "
(off) and remove the key, and remove
[ECM00682]
Maintenance
Turn off the engine and wait 3 minutes.
Recheck the oil level using the oil level
check window to be sure the level falls
between the upper and lower marks. Fill
with oil if it is below the lower mark, or
drain to the specified level if it is above
the upper mark.
Dispose of used oil according to local
regulations.
WARNING
"
50

Advertisement

Table of Contents
loading

Table of Contents