Changing Engine Oil - Yamaha F2.5 Owner's Manual

Maintenance
ECM00490
NOTICE
This procedure must be performed while
the outboard motor is in the water. A flush-
ing attachment or test tank can be used.
A diagnostic tachometer should be used for
this procedure. Results may vary depending
on whether testing is conducted with the
flushing attachment, in a test tank, or with the
outboard motor in the water.
1. Start the engine and allow it to warm up
fully in neutral until it is running smoothly.
TIP:
Correct idling speed inspection is only possi-
ble if the engine is fully warmed up. If not
warmed up fully, the idle speed will measure
higher than normal. If you have difficulty veri-
fying the idle speed, or the idle speed requires
adjustment, consult a Yamaha dealer or other
qualified mechanic.
2. Verify whether the idle speed is set to
specification. For idle speed specifica-
tions, see page 12.
EMU30227

Changing engine oil

Change the engine oil several minutes after
the engine has been stopped, so that the oil is
still warm, but not hot.
EWM01950
WARNING
Be sure the outboard motor is securely
fastened to the transom or a stable stand.
ECM01710
NOTICE
Change the engine oil after the first 20
hours of operation or 3 months, and every
100 hours or at 1-year intervals thereafter.
Otherwise the engine will wear quickly.
49
1. Put the outboard motor in an upright po-
sition (not tilted). NOTICE: If the motor
is not level, the oil level indicated on
the dipstick may not be accurate.
[ECM01860]
2. Prepare a suitable container that holds a
larger amount than the engine oil capaci-
ty. Loosen and remove the drain screw
while holding the container under the
drain hole. Then remove the oil filler cap.
Let the oil drain completely. Wipe up any
spilled oil immediately.
1. Drain screw
3. Put a new gasket on the oil drain screw.
Apply a light coat of oil to the gasket and
install the drain screw.
Drain screw tightening torque:
18.0 Nm (1.84 kgf-m, 13.3 ft-lb)