Table of Contents
Advertisement
Note:
Do not connect the power cord to a 120 V AC 60 Hz outlet
until all connections have been made.
TV Antenna Connections
If you are using an antenna system, follow these instructions. If
you are a cable (CATV) subscriber, skip ahead to page E12 for
the proper connections.
The DVD/VCR must be connected "between" the antenna and
the TV. First, disconnect the antenna from the TV and connect it
to the DVD/VCR. Then connect the DVD/VCR to the TV. Below
are 3 common methods of connecting an antenna system to a
DVD/VCR. Find the type of antenna system you are using and
follow the connection diagram.
1. Combination VHF/UHF Antenna with 75 ohm Coaxial
Cable
75 ohm Coaxial
Cable
2. Combination VHF/UHF Antenna with 300 ohm Twin Lead
(Flat) Wire
300 ohm Twin Lead
(Flat) Wire
BASIC CONNECTIONS
DVD/VCR OUTPUT
AM LOOP
VHF/UHF
VIDEO
IN
(
)
FM 75Ω
ANT.
L
AUDIO OUT
AUDIO
(6–CHANNEL)
OUT
R
3
4
(
)
CH
CH
TV
DVD/VCR
Matching Transformer
300 ohm input
75 ohm output (not supplied)
DVD/VCR OUTPUT
AM LOOP
VHF/UHF
VIDEO
IN
(
)
FM 75Ω
ANT.
L
AUDIO OUT
AUDIO
(6–CHANNEL)
OUT
R
3
4
CH
CH
(
TV
)
DVD/VCR
3. Separate VHF and UHF Antennas
VHF
UHF
300 ohm Twin
Lead (Flat) Wire
75 ohm Coaxial
Cable
Note:
If both VHF and UHF antennas have 300 ohm twin lead (flat)
wires, use a combiner having two 300 ohm inputs and one 75
ohm output.
Notes:
•
A clear picture will not be obtained by the DVD/VCR unless
the antenna signal is good. Connect the antenna to the DVD/
VCR properly.
•
For better quality recording, an indoor antenna or a telescopic
antenna is not recommended. The use of an outdoor type
antenna is required.
•
If you are not sure about the connection, please refer to
qualified service personnel.
-E9-
Combiner
75/300 ohm inputs
75 ohm output (not supplied)
DVD/VCR OUTPUT
AM LOOP
VHF/UHF
VIDEO
IN
(
)
FM 75Ω
ANT.
L
AUDIO OUT
AUDIO
(6–CHANNEL)
OUT
R
3
4
(
)
CH
CH
TV
DVD/VCR
Advertisement
Table of Contents
