Using With The Floor Stand/Speaker System - Sony KLV-40ZX1M Operating Instructions Manual

Television - lcd / led: 40" bravia® zx series lcd monitor
Hide thumbs Also See for KLV-40ZX1M:
Table of Contents

Advertisement

Available languages

Available languages

Using with the Floor Stand/Speaker System

Floor Stand:
SU-FL71M
Speaker System:
SS-WAL700
Sound does not output from the LCD Monitor when the supplied Table-Top Stand is removed to use the LCD Monitor
with the Floor Stand. In this case, use the LCD Monitor with the exclusive Speaker System (optional) to output sound.
Installing With the Unit.
The following steps must be performed to correspond with the installation step in the instructions manual
of the optional accessories. Follow the instructions in this manual referring to the instruction manual
supplied with the accessories.
For Speaker System users, first see the instruction
manual of the Floor Stand.
Follow steps below instead of "2 Preparing for
the installation of the TV" (page 6) of the
instruction manual supplied with the Floor Stand.
1
Make sure that the Table-Top Stand is
removed (if necessary).
• The stand is not attached to the LCD Monitor
when unpacking. Place the unit face down.
• If the Table-Top Stand has already been attached,
remove the stand (see page 6).
2
Place spacers.
When the Speaker System is not installed, use
all four spacers (silver - supplied with your
LCD Monitor).
24
US
Use the accessories supplied with this unit when
installing.
Spacers (silver) (2)*
* Use four spacers when the Speaker System is not installed.
1 Remove four screws
from the rear of the
LCD Monitor.
2 Place spacers
(silver - supplied with
your LCD Monitor).
3
Install the Bracket I J on the LCD Monitor.
Place the Bracket I J aligning with the screw
1
holes that became available in step 2.
Temporarily fix two Screws M6 × 20 (supplied
2
with your LCD Monitor) in the upper holes of
the Bracket. When the Speaker System is not
installed, tighten all four screws.
Screws M6 × 20
(supplied with your
LCD Monitor)
I
Go to step 5 when using only the Floor Stand.
Screws M6 × 20 (4)
When the Speaker
System is installed,
place two spacers
(yellow - supplied with
your Speaker System)
on the lower part.
J

Advertisement

Table of Contents
loading

Table of Contents