Preparation For Wall-Mounting - Sony Bravia KDL-26NL140 Operating Instructions Manual

Preparation for Wall-Mounting

This TV can be installed on a wall by using a Wall-
Mount Bracket (sold separately). Before mounting
the TV on a wall, the Table-Top Stand must be
removed from the TV.
~
• Do not remove the Table-Top Stand for any reason other
than to wall-mount the TV.
• For product protection and safety reasons, Sony
strongly recommends that you use the Wall-Mount
Bracket model designed for your TV and the wall-
mounting of your TV should be performed by a
Sony dealer or licensed contractor.
Use your TV with the following WALL-MOUNT
BRACKET.
KDL-26NL140
Sony Wall-Mount
SU-WL100
Bracket Model No.
• For bracket installation, refer to the instructions on
page 9 and the instruction guide provided by the Wall-
Mount Bracket model for your TV. Sufficient expertise
is required in installing this TV, especially to determine
the strength of the wall for withstanding the TV's
weight.
• Be sure to store the removed screws and the Table-Top
Stand in a safe place until you are ready to reattach the
Table-Top Stand. Keep the screws away from
children.
8
Sony TV Model No.
KDL-32NL140
KDL-37NL140
SU-WL500
Follow the simple steps below to remove the Table-
Top Stand:
1
Disconnect all the cables from the TV.
2
Gently lay the TV (face down) onto a level and
stable surface covered with a thick and soft
cloth. Make sure the Table-Top Stand is
hanging over the edge.
3
Remove the 4 screws from behind the TV as
indicated below. Do not remove any other
screws from the TV.
4
Secure the Mounting Hooks to the rear of the
TV. For more details, refer to Installing the
Wall-Mount Bracket and also the Instruction
Guide provided by the Wall-Mount Bracket
model for your TV.
~
• If an electric screwdriver is used, set the torque to
tighten at approximately 1.5 N·m {15Kgf·cm}.