Bundling The Connecting Cables; Preparation For Wall-Mounting - Sony BRAVIA KDL-40SL140 Operating Instructions Manual

Bundling the Connecting Cables

You can bundle the connecting cables as illustrated
below.
~
• Do not bundle the AC power cord with other connecting
cables.
8

Preparation for Wall-Mounting

This TV can be installed on a wall by using a Wall-
Mount Bracket (sold separately). Before mounting
the TV on a wall, the Table-Top Stand must be
removed from the TV.
~
• Do not remove the Table-Top Stand for any reason other
than to wall-mount the TV.
• For product protection and safety reasons, Sony
strongly recommends that you use the Wall-Mount
Bracket model designed for your TV and the wall-
mounting of your TV should be performed by a
Sony dealer or licensed contractor.
Use your TV with the following WALL-MOUNT
BRACKET only.
Sony Wall-Mount Bracket Model No.
• For bracket installation, refer to the instructions on
page 9 and the instruction guide provided by the Wall-
Mount Bracket model for your TV. Sufficient expertise
is required for installing this TV, especially to
determine the strength of the wall that will withstand
the TV's weight.
• Be sure to store the removed screws and Table-Top
Stand in a safe place until you are ready to reattach the
Table-Top Stand. Keep the screws away from
children.
• Be sure to use the screws supplied with the Wall-Mount
Bracket when attaching the mounting hooks to the TV
set.
The supplied screws are designed so that they are 8 mm
to 12 mm in length when measured from the attaching
surface of the mounting hook. The diameter and length
of the screws differ depending on the Wall-Mount
Bracket model. Use of screws other than those supplied
may result in internal damage to the TV set or cause it
to fall, etc.
8-12 mm
Screw (supplied with the Wall-Mount
Bracket)
Mounting Hook
Rear of the TV set
Sony TV Model No.
KDL-40SL140
KDL-46SL140
SU-WL500