Power-Up; Battery Supply - Honeywell GENT COMPACT-MAINS-DAU Commissioning Instructions

Power-up

Battery supply

a
Ensure the battery lead is connected to the batteries
Ensure the batteries are fitted inside the enclosure in front of the transformers.
b
c
Ensure the end connector
Note: The
"
The panel makes use of sealed lead acid type batteries which can have a useful life of up to 5 years from the
date of manufacture. It is strongly recommended that batteries are replaced after 4 years of use. Batteries must be
disposed of as per recommendation made by battery manufacturer.
&
Always use the recommended replacement battery, as there is a risk of an explosion if incorrect
batteries are used.
www.acornfiresecurity.com
k
j
on the battery lead is fitted to socket P7 on the PSU.
P2
12V 7Ah
Powersonic
PS-1270 F1
Mains Powered DAU will not power up until the mains is switched ON.
www.acornfiresecurity.com
in the manner illustrated below.
Part of the Mains Powered DAU
P1
PB9 PB16 ACS CONFIG ACS CONFIG
P11 CAN CAN SW1
H
DISABLE DISABLE
EMIC
P6
0V
ENABLE L ENABLE
0V Tx Rx
RESET
P9
-
+
12V 7Ah
Mains Powered DAU
AMP 1
P22
P2
P1
P3
AMP 2
P21
P7
BATT
POWER
SUPPLY
Red
Black
+
-
11