Assembling The Control Cabling - Husqvarna 536LiP4 Workshop Manual

9.16 Assembling the control cabling

1
Place the bottom section of the cabling and the fan
in the battery housing and connect the connector
to the control unit.
Assemble the fan, making sure it is positioned in
the correct direction.
2
Assemble the keypad. Make sure the surface is
clean.
Plug in the connector and connect the cable to
the main switch, place the parts in the operating
handle. NB! Make sure to apply grease to the
contact surfaces and also the connector, see
service data.
See figure 30b.
3
Lay the cabling in place in the control handle.
4
Assemble the throttle trigger lock and throttle
trigger as described in "8.2 Assembling the throttle
trigger lock and throttle trigger" on page 25.
5
Lay the cabling in place in the cable tray and
assemble the control handle and battery housing
as described in "7 Basic dismantle/assembly" on
page 20
Fig 29b
C
Fig 30b
Repair Instructions
B
A
English – 43