Basic dismantle/assembly
7.4 Control handle
Place something under the other handle half so
that it does not come loose from the shaft.
Loosen the screws (6x) and lift off the handle.
Assemble in the reverse order.
Tightening torque 2 ~ 3 Nm.
7.5 Battery housing
Loosen the screws (4x) and lift off half the battery
housing.
Assemble in the reverse order.
Tightening torque 2 - 3 Nm.
7.6 Chain and bar
Unscrew the bar nut and remove the motor cover.
Dismantle the circlip, washer and spur wheel.
Lift off the chain and bar
Change circlip and washer if there are any visible
defects.
Assemble in the reverse order.
WARNING!
Always use gloves when working
with cutting equipment.
22 – English