Table of Contents
Advertisement
2. Turn the vertical aiming screw (C) until the level
bubble (D) is lined up with zero.
Front Turn Signal Lamps
The turn signal bulb is located in the front fascia.
1. Remove the panel on the underside of the bulb assembly
by pulling the two fasteners that hold it in place.
2. Reach in to press the locking tab and twist the bulb
-
socket one
quarter of a turn counterclockwise and
pull the bulb out of the socket.
3. Replace the bulb, then reassemble by reversing Steps
1 and 2.
Taillamps/Rear Turn Signal/Back-Up
Lamps
Taillamps: A, B and C
Rear Turn Signal: A and C
-
Back
Up Lamps: D
The entire taillamp assembly must be removed to
change any of these bulbs.
yellowblue
6-35
Advertisement
Table of Contents
