Advertisement
Steam Refresh:
The Steam Refresh cycle releases wrinkles and refreshes items. It is recommended for small loads of 1-4 items. There are two preset cycles.
The default cycle applies a medium-temperature heat for 30 minutes to the load. The alternate cycle applies a high-temperature heat for 20
minutes.
DR7:
By default the cycle is set to 30 minutes at medium heat. To initiate the 20 minute, high heat cycle, toggle the Temp selection to High.
DR5:
Set the Cycle Selection to Steam Refresh. Setting the Fabric Selector to Delicate, Perm Press or Regular initiates the 30 min, medium
heat cycle. If the Fabric Selector is set to Heavy Duty, the 20 min, high heat cycle is initiated. Auto-Dryness is ignored unless set to Dry
& Extended Tumble.
Pet Plus (DR7 only):
The Pet Items cycle dries and refreshes bulky pet items. The default cycle is a 55-minute, high-temperature heat cycle with Anti-Static and
Steam Boost on. This cycle can be fully customized to the pet item being dried. Temperature, Time, and Options can be adjusted as needed.
You can save these cycles using the Favorites option to quickly use again.
The Pet Hair Remover cycle is used to remove pet hair from dry items. It is a set 10-minute cycle and can be used stand-alone, or as pre-
wash cycle before putting items in the washer. Anti-Static is on by default but can be turned off.
ENERGY STAR
cycle:
®
The DR5 and DR7 dryers are ENERGY STAR
DR7: Regular, Near Dry, EcoDry
DR5: Auto-Sensing, Regular, Near Dry
Options:
Options vary based on the model and may not be available with all cycle selections.
Steam Boost:
Use to release wrinkles and soften fabrics. Available with Auto-Sensing Heavy Duty, Regular, and Perm Press cycles as well
as Pet Items (DR7 Medium or High heat only) and Sanitize (DR5 only). Dryness/Auto-Dryness must be set to Near Dry or Dry. Cannot be used
with EcoDry.
Extended Tumble:
Prevents wrinkling by tumbling the clothes load after the end of the cycle every two minutes for up to 60 minutes.
Anti-Static (DR7 only):
Use to reduce static build-up. It can be added to Heavy Duty, Regular, Perm Press, Delicates, Pet Items, and Pet
Hair Remover cycles. Dryness must be set to Near Dry or Dry on Auto-Sensing cycles. Cannot be used with EcoDry.
EcoDry (DR7 only):
The EcoDry option will reduce total energy consumption by decreasing the temperature of the cycle setting by 10% after
the initial temperature setting has been reached.
certified. To take advantage of these energy saving options use the following cycle selections:
®
Advertisement
