IBM Proventia Management SiteProtector SP2001 Quick Start Manual page 3

Initial configuration
Enter the network information you gathered earlier.
Procedure
1. Press Enter
2. If you want to specify a personal identification number that users must enter to
3. To configure the appliance to communicate with other devices, navigate to the
Next Steps
Install a Console
Select a local workstation on which to install a SiteProtector Console.
Procedure
1. From this local workstation, point a Web browser to the Proventia Management
2. Read and accept the End User License Agreement. The system then displays
on the LCD panel. "Appliance PIN" appears in the LCD menu.
configure the appliance, press Enter
provided, and then press Enter
Note: Use the Up
and Left buttons to navigate between the fields.
Configuration menu (using the Up
the Enter button to go into the network configuration. Enter the
information the same way you entered information in Step 2.
v IP Address (required)
v Subnet Mask
v Default Gateway
v DNS Server
v Host Name
Note: A reboot occurs after you complete your network configuration.
SiteProtector SP2001's management address: https://<configured
address>:3994.
the Proventia Management SiteProtector SP2001 home page with the following
three links:
IBM Proventia Management SiteProtector SP2001 Quick Start Guide
, specify a 4-digit number in the field
again.
and Down buttons to specify digits and the Right
and Down buttons), then press
3