Residual Heat; Rear Window Defroster - BMW 2010 Z4 Owner's Manual

Table of Contents

Advertisement

Residual heat

The heat stored in the engine is used to heat the
interior.
This function can be switched on
using the right button under the
following conditions:
>
Up to 15 minutes after the engine has been
switched off
>
While the engine is at operating tem-
perature
>
As long as battery voltage is sufficient
>
At an outside temperature below 777/
25 6
The middle LED is lit when the function is on.
Automatic recirculated-air control
AUC/recirculated-air mode
Switch on the desired operating
mode by pressing this button
repeatedly:
>
LED off: outside air flows in continuously.
>
Left-hand LED on, AUC mode: a sensor
detects pollutants in the outside air. If nec-
essary, the system blocks the supply of out-
side air and recirculates the inside air. As
soon as the concentration of pollutants in
the outside air has decreased sufficiently,
the system automatically switches back to
outside air supply.
>
Right-hand LED on, recirculated-air mode:
the supply of outside air is permanently
shut off. The system then recirculates the
air currently within the vehicle.
If condensation starts to form on the
inside window surfaces during operation
in the recirculated-air mode, you should switch
it off while also increasing the air flow rate as
required.
The recirculated-air mode should not be used
over an extended period of time; otherwise, the
air quality inside the car will deteriorate contin-
uously.<
98
Online Edition for Part no. 01 41 2 602 883 - © 08/09 BMW AG
Defrosting windows and removing
condensation
Quickly removes ice and conden-
sation from the windshield and
front side windows.
Switch on the cooling function as well.

Rear window defroster

The defroster switches off auto-
matically after a certain time or
when the hardtop is opened.
Ventilation
1
Lever for changing the direction of the
air flow.
2
Thumbwheels for opening and closing the
air vents.
3
Thumbwheel for adjusting the amount of
cool air from the vents to the upper body
area. In this way you can optimize the air
temperature for the upper body area.
Ventilation for cooling
Adjust the vent outlets to direct the flow of cool
air in your direction, for instance if it has become
too hot in the car.
Draft-free ventilation
Set the vent outlets so that the air flows past
you and not straight at you.
Microfilter/activated-charcoal filter
The microfilter traps dust and pollen in the
incoming air. The activated-charcoal filter pro-
vides additional protection by filtering gaseous
pollutants from the outside air. Your BMW cen-
ter replaces this combined filter during routine
maintenance.

Advertisement

Table of Contents
loading

Table of Contents