BMW 2009 328 Owner's Manual page 80

Settings on the Control
Display
Language on the Control Display
Setting the language
iDrive, for operating principle refer to page 16.
1. "Settings"
2. "Language/Units"
3. "Language:"
4. Select the desired language.
The setting is stored for the remote control cur-
rently in use.
Setting the voice dialog
Switch between a standard dialog and a short
dialog.
iDrive, for operating principle refer to page 16.
1. "Settings"
2. "Language/Units"
3. "Speech mode:"
4. Select the desired dialog.
The setting is stored for the remote control cur-
rently in use.
78
Online Edition for Part no. 01 41 2 602 099 - © 10/08 BMW AG
Warning signal volume
In vehicles equipped with a single drive, you can
raise or lower the volume of the warning signals,
e.g. the 'fasten safety belt' reminder, relative to
the entertainment sound output. The warning
signals have a fixed minimum and maximum
volume that cannot be dropped below or
exceeded.
iDrive, for operating principle refer to page 16.
1. "Settings"
2. "Tone"
3. "Volume settings"
> "Speed volume": speed-dependent vol-
ume control
> "PDC": volume of the PDC
relative to the entertainment sound out-
put
> "Gong": volume of the signal tone, e.g.
for the 'fasten safety belt' reminder, rela-
tive to the entertainment sound output
Brightness of Control Display
The brightness is automatically adapted to the
ambient lighting conditions. However, you can
change the basic setting.
iDrive, for operating principle refer to page 16.
1. "Settings"
2. "Central display"
*
signal tone