Audio Technica ATW-1701 Assembly And Set-Up

Download this manual

Audio Technica ATW-1701 Wireless Mic System – Assembly & Setup

In the box you should have the following:

•

Belt Pack Transmitter

•

Wireless Receiver

•

Bracket

•

XLR to Mini Jack Cable

•

USB charging cable

•

HT Aeromic

1. Slide the bracket's clip into the mount on the side of the Bose

system, noting the directional arrows on the bracket.

2. Tighten the circular screw using thumb and fore finger, until the

clip feels secure, being careful not to over tighten.

Page 1 Audio Technica ATW-1701 Wireless Mic System – Assembly & Setup In the box you should have the following: • Belt Pack Transmitter • Wireless Receiver • Bracket • XLR to Mini Jack Cable • USB charging cable • HT Aeromic 1.
Page 2 3. Clip the receiver into place. 4. Connect the mini jack end of the XLR to mini jack cable into the ‘OUTPUT’ socket on the receiver. 5. Connect the XLR end of the cable to the input socket on the top channel. (Tone match switch should be set to mic symbol)
Page 3 6. Connect the microphone plug to the socket atop the beltpack receiver, paying close attention to the grooves in each, so as not to damage the pins. 7. A satisifying click will be heard when the plug is succesfully connected. 8.
Page 4 9. Repeat Step 8 on the beltpack/transmitter. 10. From the included manual: Press the System ID button on the receiver to choose an ID number from 1 to 8. The receiver’s display will show your new ID and begin to blink. Within 15 seconds, press and hold the Pair button on the receiver for about one second.
Page 5 11. Turn on the BOSE unit and turn up the channel volume to the desired level. 12. To use Bluetooth on the BOSE speaker, press and hold the Bluetooth button to pair from your phone or device.
Page 6 N.B. The devices should be set up prior to dispatch, though please check the switches on the receiver are in this position before opertation.