Advertisement
Available languages
Available languages
Cleaning the clear bin
• Ensure the machine is disconnected from the charger before removing the clear bin. Be
careful not to pull the "ON" trigger.
• Remove the wand and floor tool.
• To remove the cyclone, hold the machine by the handle, pull the red lever towards you
and lift upwards until the bin opens, then push in the red button located behind the
cyclone and lift the cyclone out.
• To detach the clear bin from the machine, pull back on the red catch located at the
base, slide the clear bin down and carefully remove forwards from the main body.
• Clean the clear bin with a damp cloth only.
• Do not use detergents, polishes or air fresheners to clean the clear bin.
• Do not put the clear bin in a dishwasher.
• Ensure the clear bin is completely dry before replacing.
• To replace the clear bin, align the tabs on the clear bin with the grooves on the main
body and slide upwards into place until the catch clicks.
• Slide the cyclone into the grooves of the main body and push downwards until it is in its
normal position and manually close the base of the bin – the base will click when it is
securely in place.
Washable parts
Your machine has washable parts, which require regular cleaning. Follow the
instructions below.
Washing your filter
• Ensure the machine is disconnected from the charger before removing the filter. Be
careful not to pull the "ON" trigger.
• Your machine has one washable filter, located as shown.
• To remove the filter, lift it out of the top of the machine.
• Check and wash the filter regularly according to instructions to maintain performance.
• The filter may require more frequent washing if vacuuming fine dust or if used mainly in
"POWERFUL SUCTION" mode.
• Wash the filter with cold water only.
• Run water over the outside of the filter until the water runs clear.
• Squeeze and twist with both hands to make sure the excess water is removed.
• Lay the filter on its side to dry. Leave to dry completely for a minimum of 24 hours.
• Do not put the filter in a dishwasher, washing machine, tumble dryer, oven, microwave
or near an open flame.
• To refit, place the dry filter back into the top of the machine. Make sure it is seated
properly.
Looking for blockages
The motor will pulse when there is a blockage. Please follow the instructions below to
locate the blockage:
• Ensure the machine is disconnected from the charger before looking for blockages. Be
careful not to pull the "ON" trigger.
• Do not operate while checking for blockages as doing so could result in personal injury.
• Beware of sharp objects when checking for blockages.
• To check for blockages in the main body of the machine, remove the clear bin and
cyclone as per the instructions in the cleaning the clear bin section and remove the
blockage. Please consult the 'Stubborn blockages' section of the illustrations for
further guidance.
• If you cannot clear an obstruction you may need to remove the brush bar. Use a coin to
unlock the fastener marked with a padlock. Remove the obstruction. Replace the brush
bar and secure it by tightening the fastener. Ensure it is fixed firmly before operating
the machine.
• This machine has carbon fiber brushes. Take care if coming into contact with them, as
they may cause minor skin irritation. Wash your hands after handling the brushes.
• Refit all parts securely before using.
Blockages – automatic cut-out
• This machine is fitted with an automatic cut-out.
• If any part becomes blocked the machine may automatically cut out.
• This will happen after the motor pulses a number of times (i.e switches on and off in
quick succession).
• Leave to cool down before looking for blockages.
• Ensure the machine is disconnected from the charger before looking for blockages.
Failure to do so could result in personal injury.
• Clear any blockage before restarting.
• Refit all parts securely before using.
Charging and storage
• This machine will switch "OFF" if the battery temperature is below 37.4°F (3°C). This is
designed to protect the motor and battery. Do not charge the machine and then move it
to an area with a temperature below 37.4°F (3°C) for storage purposes.
• To help prolong battery life, avoid recharging immediately after a full discharge. Allow
to cool for a few minutes.
• Avoid using the machine with the battery flush to a surface. This will help it run cooler
and prolong battery run time and life.
Battery safety instructions
• If the battery needs replacing please contact the Dyson Helpline.
• Use only Dyson chargers for charging this Dyson machine.
• The battery is a sealed unit and under normal circumstances poses no safety concerns.
In the unlikely event that liquid leaks from the battery do not touch the liquid and
observe the following precautions:
– Skin contact – can cause irritation. Wash with soap and water.
– Inhalation – can cause respiratory irritation. Expose to fresh air and seek medical
advice.
– Eye contact – can cause irritation. Immediately flush eyes thoroughly with water for
at least 15 minutes. Seek medical attention.
– Disposal – wear gloves to handle the battery and dispose of immediately, following
local ordinances or regulations.
Caution
The battery used in this device may present a risk of fire or chemical burn if mistreated.
Do not disassemble, short contacts, heat above 140°F (60°C), or incinerate. Keep
away from children. Do not disassemble and do not dispose of in fire.
Disposal information
• Dyson products are made from high grade recyclable materials. Recycle
where possible.
• Dispose of or recycle the battery in accordance with local ordinances or regulations.
• The battery should be removed from the product before disposal.
Online support
• For online help, general tips, videos and useful information about Dyson.
– www.dyson.com.mx/support
Dyson customer care
Thank you for choosing to buy a Dyson machine.
After registering your 2 year warranty, your Dyson machine will be covered for parts
and labor (excluding filters) for 2 years from the date of purchase, subject to the terms
of the warranty. If you have any questions regarding your Dyson machine, visit www.
dyson.com.mx for online help, general tips and useful information about Dyson.
Alternatively, you can contact us via email or phoning Dyson Customer Care with your
serial number and details of where/when you bought the machine.
If your Dyson machine needs a repair, email or phone Dyson Customer Care so we
can discuss the available options. If your Dyson machine is under warranty, and it is a
covered repair, it will be repaired at no cost.
Please register as a Dyson machine
owner
To help us ensure that you receive prompt and efficient service, please register as a
Dyson machine owner.
• Register online at www.dyson.com.mx.
This will confirm ownership of your Dyson machine in the event of an insurance loss,
and enable us to contact you if necessary.
Product information
Please note: Small details may vary from those shown.
11
Advertisement
