Printer Configuration - Brady Cutter CU4 Operator's Manual

Printer Configuration

Once the cutter is connected to the printer, the printer will automatically
recognize it on turn on. Once the cutter is recognized, the printer can be
operated in cut mode. The printer can be configured to suit the individual
requirements of cut mode in the „Setup" menu. When the cutter is
installed, the „Cutter" menu will appear.
NOTICE!
Pay attention to the detailed instructions for configuration in the
Printer's Operator Manual.
1. For setting the cutter parameters select „Setup" -> „Machine param."
-> „Cutter".
Setup
Machine param.
Parameter
Cutter
Table 1 Cutter parameters
2. Under „Setup" -> „Print parameters" the method for recognizing the
start of label and the method of backfeed when using cut mode can
be selected.
Setup
Print parameters
Parameter
Label sensor
Backfeed
Table 2 Parameters „Label sensor" and „Backfeed"
6
Meaning
Cut position Offset of the cut position relative to
the rear label edge
Default : 0,0 mm
Meaning
Method of label sensing
Default : Gap sensor
Method of backfeed when using the
dispense mode or the cut mode
Default : smart
Selection
+9,9
...
-9,9
Selection
Gap sensor
Bottom reflect
Endless media
smart
always
Cutter CU4