Page 2
Brady’s satisfaction to have been defective at the time Brady sold it. This warranty does not extend to any persons obtaining the product from the buyer.
Introduction Instructions Important information and instructions in this documentation are designated as follows: Danger! Draws attention to an exceptionally great, imminent danger to your health or life due to hazardous voltages. Danger! Draws attention to a danger with high risk which, if not avoided, may result in death or serious injury. Warning! Draws attention to a danger with medium risk which, if not avoided, may result in death or serious injury.
• The device is designed to use on a Brady printer of the A8500 series. Any other use or use going beyond this shall be regarded as improper use. The manufacturer/supplier shall not be liable for damage resulting from unauthorized use;...
Introduction Safety Marking Warning of damage by moving parts! Cylinder is under pressure, even if it is switched off. Possible residual energy! Danger of crushing hand and/or fingers by the moving pad! Attention! Never remove or cover safety markings! Replace them in case of damage! Fig.
Label transfer method Tamp pad Tamp pad Tamp pad Blow pad with foam with label stop 4114 L/R 11 F 4114 L/R 12 F 4114 L/R 61 F 4014 L/R 2100 Label width in mm 10 - 114 10 - 114...
Product Description Overview Fig. 1 Device overview - front view 1 Cover 6 Knurled screw for attaching the applicator to the 2 Compressed air connector printer 3 Shutoff valve 7 Hinges 4 Pad (customized) 8 SUB-D 15 Interface to the printer 5 Blow tube for supporting air User Manual...
Product Description Contents of Delivery • Applicator (1) • Screws (part of the pad) (2) • Pad (as ordered) (3) • Blow tube (4) • Documentation Fig. 2 Contents of delivery Note! Please keep the original packaging in case the applicator must be returned. Attention! The device and printing materials will be damaged by moisture and wetness.
Mounting Fig. 3 Mounting applicator on printer Attention! Initiation, adjustments and changing of parts is only for qualified service personal only. Mount the applicator 1. Hang the applicator with the female part of hinges (1) at the printer mounted hinges parts (2). 2.
Operation Standard Operation Check all external connections. Load the material. Ensure that the locking system is locked "User Manual" of the printer. Open the shutoff valve. Attention! Ensure that the pad is not covered by a label when switching on the printer-applicator system. Otherwise the vacuum sensor may be calibrated incorrectly.
Error Messages Error Messages of the Printer For detailed information about printer errors (e.g. 'Paper out', 'Ribbon out', etc.) Check the user manual of the printer. Error treatment: Clearing the error results. Press the to synchronize the label feed, remove the left over labels manually. To quit the error state press Repeat .
Licenses Reference to the EU Declaration of Conformity The BradyPrinter™ A8500 Label Applicator complies with the relevant fundamental regulations of the EU Rules for Safety and Health: Directive 2006/42/EC on machinery Directive 2014/35/EU relating to electrical equipment designed for use within certain voltage limits Directive 2014/30/EU relating to electromagnetic compatibility Directive 2011/65/EU on the restriction of the use of certain hazardous substances in electrical and electronic equipment...
Page 14
Brady Worldwide, Inc Brady EMEA Brady Corporation Asia 6555 West Good Hope Road Lindestraat 20 1 Kaki Bukit Crescent Milwaukee, WI 53223 9240 Zele Singapore 416236 bradyid.com Belgium bradycorp.com/global bradycorp.com/global...