Changing The Blades - Brady Cutter CU4 Operator's Manual

Changing the Blades

1. Turn the printer off and demount the cutter from the printer.
2. Turn the axle (3) of the circular blade (2) with a screwdriver for
slotted head screws (slot width 7mm) so that the inscription (1) of the
blade points downward.
In this position the set screw (4) on the „gear-wheel circular blade"
can be achieved from the rear of the cutter.
Loosen this set screw (4) a few turns.
Fig. 6
3. Hang out the spring (13) on the bearing plate (15) and the linear
blade (11).
NOTICE!
Attend on the washers (A, B, C) for the blades (2,11) when you
demount the bearing plate. The washers could get lost because of
theire smallness.
CAUTION!
Always keep the linear knife with one hand (11) in its position and
push its axle slightly to the mounting plate (9) of the cutter, because
the spring (6) is tense.
4. Unscrew the screws (8) and remove the bearing plate (15) sideways.
5. Take the circular blade (2) out of its bearing (5).
Now you can slacken the spring (6) of the linear blade.
If you don't want to change the linear blade you can skip to #9.
6. Take the spring (6) and the linear blade (11) from the mounting plate
(9).
7. Insert the axle of the (new) linear blade withe the washer (B) in the
bearing (10) of the mounting plate. (The inscription of the linear blade
has to point downwards.)
8. Hang the spring (6) without tense on the pins of the mounting plate
(9) and the linear blade (11).
10
1 2 3
Loosen the screws
4
Cutter CU4