Pride 36 Owner's Manual page 15

SHROUD PANELS
On certain models, you can change the color of your Travel
Scooter by removing the colored plastic shroud panel pieces
and replacing them with one of the other supplied sets. The
panels are held in place by a hook and loop reusable fastener.
See Travel Scooter Features Table (inside front cover).
To remove the shroud panel pieces:
1. Use your fi nger to locate the push hole behind each
shroud piece.
2. Push through the hole to separate the piece from the
Travel Scooter. See fi gure 15.
To remove the tiller console visor:
1. Gently pull the top of the visor away from the tiller
console, then slowly lift it up and away from the tiller
console. See fi gure 16.
To reinstall the shroud pieces, place each piece in its appropriate location and push with slight pressure to secure
the reusable fastener.
NOTE: When installing the front and rear fender panels, make sure the tab at the bottom of each panel is
inserted into the tab opening before securing the panel. See fi gure 15.
Figure 16. Tiller Console Visor
Travel Scooter Series
I I . Y O U R T R AV E L S C O O T E R
1
2
1
Figure 15. Fender Panels
2
1
IDENTIFICATION KEY
1. Rear Fender Panel
2. Front Fender Panel
2
2
1
2
1
15