Kickstand Replacement Process; Procedure - Removal (Kickstand) - Microsoft Surface Go 2 Replacement Manual

Kickstand Replacement Process

Preliminary Requirements
IMPORTANT: Be sure to follow all special (bolded) notes of caution within each process section.
Required Tools and Components
Tools:
•
3IP (Torx-Plus) driver
o
Soft ESD safe mat
o
Microfiber cloth
o
Components:
•
New Kickstand FRU
o
(FRU includes new 3IP screws)
Prerequisite Steps:
Power off device - Ensure device is powered off and disconnected from a power supply.
•
General Safety - Check to make sure that general guidelines and ESD compliance steps are followed prior to
•
opening device. Refer to Prior to Device Disassembly section
Verify device model number – Ensure the model number on the new kickstand FRU matches the model
•
number on the backside of the device.
Procedure – Removal (Kickstand)
1. Place device screen-down on soft ESD safe mat. Ensure mat is clear of any abrasive material that may
scratch the Touch Display Module (TDM) glass.
2. Extend the kickstand to approximately 90°
11
(page 10) for details.
M1154224-001