Krell Industries Showcase DVD Installation And Setup Manual page 4

Hdmi upgrade

Hide thumbs Also See for Showcase DVD:

Audio sync switch

Figure 3

Showcase DVD Back Panel

Showing HDMI Connector,

After HDMI Adapter PCB Is

Installed

Connector through hole with

HDMI connector in place

two 4-40 x 1/4-inch SHSC

Showcase DVD /

HDMI Upgrade

Steps J– M. Install the HDMI Adapter PCB

J. Locate the HDMI connector on the back edge of the supplied HDMI adapter PCB

(not illustrated) and slide it into the HDMI connector through hole (6) on the back

panel (see Figure 3) of the Showcase DVD.

K. Secure the HDMI adapter PCB to the back panel using two supplied 4-40 x 1/4-

inch SHSC (7) (see Figure 3).

L. Position the left front through hole on the HDMI adapter PCB over the standoff

protruding up from the analog output board (not illustrated).

M. Thread one supplied 4-40 x 1/4-inch SHSC (28) onto the standoff to support the

front left corner of the HDMI adapter PCB (see Figure 4).

Steps N– P. Install the HDMI Power PCB

N. Mount the supplied HDMI power PCB onto the Showcase DVD chassis using the

four supplied 4-40 x 1/2-inch SHCS (8); one in each corner of the board. (see

Figure 4).

O. Secure the regulator to the chassis with the supplied 4-40 x 3/8-inch FHTS (9)

and cap it with the supplied 4-40 Kepnut (10) (see Figure 4).

P. Tighten until "just snug". The torque spec is 5-8 in lbs.