Ricoh B3058637 Operating Instructions Manual page 20

Configuring the Printer for the Network with the Operation Panel
I
If you use TCP/IP, you can make
settings for "Network Boot".
You can select how to assign the
printer's address using the com-
puter. Select one of the items on
the following table.
Menu item on the
2
panel display
ARP+PING
ARP & RARP
ARP & BOOTP
APR&RARP&BOOTP
None
(Default Seting)
RARP + TFTP
BOOTP
RARP & BOOTP
DHCP
*1
ARP+PING
*2
RARP+TFTP
*3
BOOTP
*4
DHCP
Note
You should set up your server,
if you
"RARP+TFTP", "BOOTP", or
"DHCP".
A Press [↑][↓] until the following
message appears.
14
Available method
*1 *2 *3
AR RA BO DH
'
' '
' '
' ' '
'
'
' '
'
want to use
THYS850E
B Press [Enter #].
The current setting appears on
the panel display.
C Press [↑][↓] until the method
*4
you want to use appears.
D Press [Enter #].
J
If you use NetWare, select the
frame type for NetWare.
Select one of the items below if
necessary.
• Auto Select (Default)
• Ethernet 802.3
• Ethernet 802.2
• Ethernet II
• Ethernet SNAP
Note
Usually, you can use the default
setting ("Auto Select"). With
"Auto Select", the frame type
detected by the printer first is
adopted. If your network can
use more than two frame types,
the printer may fail to select the
correct frame type. In this case,
select the appropriate frame
type.
A Press [↑][↓] until the following
message appears.
THYS850E