Wolf 39239 Series Mounting Instructions page 26

26
KGXD - 110 - 1000 horizontal
Remove the bolts for fastening the flap. Remove the flap. If
access is difficult, the panel on the flap side can be removed.
Unscrew the side supports on the left and right from the
assembly side (only 1 sheet per side).
First seal the underside of the support frame with swelling
tape.
Place the support frame in the device over the open side,
and align in the supports.
Subsequently, fix the frame to the still installed supports
using self-tapping screws.
Unpack the plate elements as described by the manufactu-
rer, and put them one at a time onto the support frame, seal
and bolt them (Described in more detail below). For ease of
assembly, only push the cubes into the final position after
complete assembly.
Place the first plate element in the final position (rear corner
on the support frame)
support frame
3062937_201508