Enabling Or Disabling The Boot Rom Setting; Booting From The Network - 3Com 3C905C-TX-M User Manual

Enabling or Disabling the Boot ROM Setting

The default NIC boot ROM setting is Enabled. This setting
must be enabled to boot from the network.
To enable or disable the NIC boot ROM setting:
1 Make sure that the NIC is installed and is connected
to the network and that the NIC driver is installed.
2 Open the Windows Start menu.
3 Select Programs, and then 3Com NIC Utilities.
4 Click 3Com NIC Doctor.
The 3Com NIC Diagnostics General screen appears.
5 Click the Configuration tab.
The Configuration screen appears.
6 Under Network Parameter, select Boot PROM.
7 Open the Set Value list box and select Enabled to
enable the boot ROM or Disabled to disable the
boot ROM.
8 Click OK to save the setting and exit the program.

Booting From the Network

The boot process for the MBA boot ROM varies depending
on the type of PC you have (BBS BIOS-compatible or
non-BBS BIOS-compatible).
If your PC was purchased recently, it may be BBS (BIOS Boot
Specification) BIOS-compatible. The BBS determines how
the system BIOS identifies boot devices in a PC (such as a
CD-ROM drive, a hard drive, or a floppy drive), allows the
user to select the boot order of these devices, and then
attempts to boot from each device in the specified order.
Refer to your PC documentation if you do not know which
type of PC you have.
Configuring the Managed PC Boot Agent (MBA) 61