Advertisement
Confirming the Current Version
reface CS
Operation
Confirm version
D#2
While holding down the D#2 key, press the [ ] (Standby/On) switch.
Confirm
If the LOOPER slider's REC lamp lights up or flashes, your reface already has firmware version 1.30 or later and does
not need to be updated. Therefore, you do not need to use this updater. If the lamps neither light up nor flash, proceed
with updating as described in
reface DX
Operation
While holding down the F#3, A3, and C#4 keys, press the [ ] (Standby/On) switch.
Confirm
If the version shown on the display is 1.30 or later, you do not need to use this updater. If the version shown is earlier than
1.30, proceed with updating as described in
"Updating Procedure."
Confirm version
F#3
A3
C#4
"Updating Procedure."
reface CS / reface DX / reface CP / reface YC V1.30 Updater Guide
2
Advertisement
