Sony LocationFree LF-X11 Operating Instructions Manual page 84

When using a LAN connection, select
[Settings] next to On the Go-Wired LAN.
The [Wired Monitor Settings] window
appears.
5
Confirm that the check box of "Automatic IP
Address Configuration (DHCP)" is checked
and the IP Address is displayed.
6
When using a wireless connection, select
[Back].
[On the Go-Wireless] window appears, and
then select [Back].
When using a LAN connection, select
[Back].
The [Monitor] window reappears.
7
Select [Settings], and then select [Exit].
Connecting via LAN (assigning an
IP address manually)
1
Perform the steps 1 to 4 in "Connecting via
LAN (DHCP)" (1 page 83).
When using a wireless connection, [Wireless
Monitor Settings] window appears.
When using a LAN connection, [Wired
Monitor Settings] window appears.
2
Clear the checks from the [Automatic IP
Address Configuration (DHCP)] and
[Automatic DNS Configuration] check
boxes. Then, while referring to the
information from your public wireless or
wired LAN service provider, enter values in
the [IP Address], [Subnet Mask], [Default
Gateway], [DNS1], and [DNS2] fields.
When you are finished, select [Set].
84
Clear this check box.
[Back] Set
3
When using a wireless connection, select
[Back].
[On the Go-Wireless] window appears, and
then select [Back].
When using a LAN connection, select
[Back].
The [Monitor] window reappears.
4
Select [Settings], and then select [Exit].
Refer to the information from
your service provider.