Table of Contents
Advertisement
Error Message
Onboard Floppy Drive IRQ
Conflict(s)
Onboard Pointing Device
IRQ Conflict(s)
Onboard IDE Secondary
Channel IRQ Conflict(s)
Onboard ECP Parallel Port
DMA Conflict(s)
Onboard Floppy Drive
DMA Conflict(s)
Onboard Floppy Drive I/O
Address Conflict(s)
Onboard IDE Secondary
Channel I/O Address
Conflict(s)
Onboard Serial Port I/O
Address Conflict(s)
Onboard Parallel Port I/O
Address Conflict(s)
Onboard Serial Port
Conflict(s)
Onboard Parallel Port
Conflict(s)
68
Possible Cause
-The IRQ allocated for the
on-board floppy drive
conflicts with another device.
-The IRQ allocated for the
on-board pointing device
conflicts with another device.
-The IRQ allocated for the
on-board IDE secondary
channel conflicts with
another device.
-The DMA allocated for the
on-board parallel port
conflicts with another device.
-The DMA allocated for the
on-board floppy drive
conflicts with another device.
-The I/O address allocated
for the on-board floppy drive
conflicts with another device.
-The I/O address allocated
for the on-board IDE
secondary channel conflicts
with another device.
-The I/O address allocated
for the on-board serial port
conflicts with another device.
-The I/O address allocated
for the on-board parallel port
conflicts with another device.
-The on-board serial port
resource conflicts with the
add-on card serial port.
-The on-board parallel port
resource conflicts with the
add-on card parallel port.
Corrective Action
-Enter BIOS Setup to
disable the on-board
floppy disk controller.
-Enter BIOS Setup to
disable the on-board
pointing device.
-Enter BIOS Setup to
disable the on-board IDE
secondary channel.
-Enter BIOS Setup to
change the on-board ECP
parallel port DMA
assignment or disable it.
-Enter BIOS Setup to
disable the on-board
floppy disk controller.
-Enter BIOS Setup to
disable the on-board
floppy disk controller.
-Enter BIOS Setup to
disable the on-board IDE
secondary channel.
-Enter BIOS Setup to
change the on-board serial
port I/O address or disable
it.
-Enter BIOS Setup to
change the on-board
parallel port I/O address or
disable it.
-Change the on-board
serial port I/O address in
BIOS Setup or change the
add-on card serial port I/O
address.
-Change the on-board
parallel port I/O address in
BIOS Setup or change the
add-on card parallel port
I/O address.
Troubleshooting
Advertisement
Table of Contents
