Fluke i6000s Flex Series Instruction Sheet

Introduction
The i6000s 24 Flex and i6000s 36 Flex AC Current Probes (the
Probe) are used with oscilloscopes, digital multimeters, recorders
or data loggers. The Probes can be used to measure AC current
up to 6000 A. The flexible measuring head allows current
measurements on conductors that are hard to reach or
inaccessible using typical clamp-on current probes.
The Probes provide a low-voltage (3 V ac) output that is
proportional to the current being measured. The Probes provide
full-scale direct readings for 60 A, 600 A, and 6000 A.
Safety Instructions
A Warning identifies conditions and procedures that are
dangerous to the user. A Caution identifies conditions and
procedures that can cause damage to the Product or the
equipment under test.
To prevent electric shock or personal injury:
•
If the Probes are used in a manner not
specified in these operating instructions,
protection provided by the Probes may be
impaired.
•
Use the Probes only if qualified.
•
Use caution during installation and use of the
Probes; high voltages and currents may be
present in circuit under test.
•
Have maintenance performed by only qualified
service personnel.
•
Protect the Probes against water and
humidity.
PN 2842359
June 2007, Rev. 1, 4/17
©2007-2017 Fluke Corporation. All rights reserved.
Specifications are subject to change without notice.
All product names are trademarks of their respective companies.
i6000s Flex
AC Current Probe
 Warning
Instruction Sheet