Panasonic KX-TGD830 Operating Instructions Manual page 24

Enhanced Call Block
Displaying and clearing the
blocked call count
The total number of blocked calls (up to
65,000) will be displayed.
1
MMENUN#790
R To exit, press MOFFN.
2
MCLEARN
3
MbN: "Yes" a MSELECTN a MOFFN
Adding to the allow name list
You can allow specific callers to pass through
by adding the caller's name to the allow name
list even if you do not know the caller's
number.
You can store up to 100 names (16 characters
max.). If the name stored in the allow name list
matches the incoming Caller ID, the unit rings.
Callers listed in the allow name list are not
required to enter the access code.
Adding allowed names from the
caller list
1
MCN CID
2
MbN: Select the desired entry. a MMENUN
3
MbN: "Save allow name" a
MSELECTN a MOFFN
Viewing/erasing an entry
1
MMENUN#794
2
MbN: Select the desired entry.
R After viewing, press MOFFN to exit.
3
MERASEN a MbN: "Yes" a MSELECTN
a MOFFN
Erasing all entries
1
MMENUN#794
2
MERASEN a MbN: "Yes" a MSELECTN
3
MbN: "Yes" a MSELECTN a MOFFN
For assistance, please visit http://shop.panasonic.com/support
24
Greeting message for automated
call block
When the unit answers a call, a greeting
message is played to the caller.
You can use either:
– your own greeting message and
pre-recorded greeting message
– pre-recorded greeting message
Recording a greeting message for
automated call block
Using this feature, the unit can play your own
greeting message and pre-recorded greeting
message.
Example of your own greeting message:
"Hi, you have reached xxxxxx (Name)."
"Thank you for your calling, You have reached
xxxxxx (Name)."
"Hi, you have reached the xxxxxx (Name)
residence."
1
MMENUN#791
2
MbN: "Yes" a MSELECTN
3
After a beep sounds, hold the handset
about 20 cm (8 inches) away and speak
clearly into the microphone (2 minutes
max.).
4
Press MSTOPN to stop recording.
5
The unit will play the recorded greeting
message for automated call block. a
MOFFN
Resetting to the pre-recorded
greeting message for automated call
block
This procedure will erase your greeting
message for automated call block and reset to
the pre-recorded one.
1
MMENUN#793
2
MYESN a MOFFN
Playing back the greeting message
for automated call block
1
MMENUN#792