Haier HWM95-261NZP Instruction Manual page 7

d. The connection of water inlet
pipe and its joints
① Press down the slider and insert
the water inlet pipe to its joints.
② Make the locking lever to hook
the joint of the water inlet pipe
and put down the slider until hear
"bang".
Check the installation status of the water inlet pipe
1. Check whether the connection of the water inlet pipe is firm.
2. After installing, open the regulator and check whether leaking water.
3. Do not bend the inlet pipe strongly.
4. Before using the washing machine, please check and confirm that
the connection between the regulator and the water inlet pipe is
firm.
Check before switching on the power
1. Check that whether the socket could withstand the washing machine's maximum power
load. But for security, the socket's maximum safe current should not less than the
maximum load current of the power line plug.
2. Check that whether the power supply voltage meets the required values.
3. Check that whether the socket is in conformity with the plug of the washing machine.
If not, replace the socket or the power line to make it consistent. If need to replace the
power line, it should be done by the professional or you need to contact the special
maintenance point of the company.
Installation and adjustment
e. The connection between water inlet pipe
① Put the nut of the water inlet pipe
② Tighten the nut of the water inlet
and the washing machine
joint into the water inlet the upper
part on the washing machine.
pipe joint to the right and confirm
that it is in place.
Note:
If the water-absorbent pad is loose or damaged,
please contact the company's after-sale service
department.