Radius - Draytek Vigor 2820 User Manual

2. Configure the PPPoE always on from 9:00 to 18:00 for whole week.
3. Configure the Force Down from 18:00 to next day 9:00 for whole week.
4. Assign these two profiles to the PPPoE Internet access profile. Now, the PPPoE
Internet connection will follow the schedule order to perform Force On or Force
Down action according to the time plan that has been pre-defined in the schedule
profiles.
3 . 7 . 3 R A D I U S
3 . 7 . 3 R A D I U S
Remote Authentication Dial-In User Service (RADIUS) is a security authentication
client/server protocol that supports authentication, authorization and accounting, which is
widely used by Internet service providers. It is the most common method of authenticating
and authorizing dial-up and tunneled network users.
The built-in RADIUS client feature enables the router to assist the remote dial-in user or a
wireless station and the RADIUS server in performing mutual authentication. It enables
centralized remote access authentication for network management.
Enable
Server IP Address
Destination Port
Shared Secret
Confirm Shared Secret
102
Check to enable RADIUS client feature
Enter the IP address of RADIUS server
The UDP port number that the RADIUS server is using. The
default value is 1812, based on RFC 2138.
The RADIUS server and client share a secret that is used to
authenticate the messages sent between them. Both sides must
be configured to use the same shared secret.
Re-type the Shared Secret for confirmation.
Vigor2820 Series User's Guide