Verizon Fios G3100 User Manual page 33

ComputER nEtWoRk ConFiguRation
• If your client device has a WPS PIN, locate the
PIN printed on the client's label or in the client
documentation. Enter the PIN number in the Enter PIN
field. The Client WPS PIN
on the user interface.
• Click Register
• Alternatively, you can enter the Router's PIN shown on
this screen into the WPS user interface of your device, if
this PIN mode is supported by your Wi-Fi device.
4. After pressing the unified button (WPS) on your Router, you
have two minutes to press the WPS button on the client
device before the WPS session times out.
When the unified button (WPS) on your Router is pressed,
the Router Status LED on the front of your Router begins
flashing blue. The flashing continues until WPS pairing to the
client device completes successfully. At this time, the Router
Status LED turns solid blue.
If WPS fails to establish a connection to a Wi-Fi client
device within two minutes, the Router Status LED on your
Router flashes red for two minutes to indicate the WPS
pairing process was unsuccessful. After flashing red, the
light returns to solid white to indicate that Wi-Fi is on.
Note: Wi-Fi Protected Setup (WPS) cannot be used if WPA3
security is enabled or SSID broadcast is disabled or if MAC
address authentication is enabled with an empty white list.
Client WPS PIN field is located in the Option 2
Register.
Enter PIN
Option 2