Buick 2011 Regal Owner's Manual page 195

To Transfer Audio to the In-Vehicle
Bluetooth System
The cell phone must be paired and
connected with the Bluetooth
system before a call can be
transferred. The connection process
can take up to two minutes after the
ignition is turned to ON/RUN or
ACC/ACCESSORY.
For vehicles without a navigation
system, press during a call
with the audio on the cell phone.
The audio transfers to the vehicle.
For vehicles with a navigation
system, press during a call
with the audio on the cell phone.
If the audio does not transfer to the
vehicle, use the audio transfer
feature on the cell phone. See the
cell phone manufacturer's user
guide for more information.
Voice Pass-Thru
Voice pass thru allows access to the
voice recognition commands on the
cell phone. See the cell phone
manufacturer's user guide to see if
the cell phone supports this feature.
To access contacts stored in the cell
phone:
1. Press .
For vehicles without a
navigation system, the
system responds Ready,
followed by a tone.
For vehicles with a
navigation system, the
system responds with a
tone. After the tone, say
Hands Free. The system
responds Ready, followed
by a tone.
Infotainment System
2. Say Bluetooth. The system
responds Bluetooth ready,
followed by a tone.
3. Say Voice. The system
responds OK, accessing
<phone name>.
The cell phone's normal prompt
messages will go through their
cycle according to the phone's
operating instructions.
Dual Tone Multi-Frequency
(DTMF) Tones
The in vehicle Bluetooth system can
send numbers and the numbers
stored as name tags during a call.
Use this feature when calling a
menu driven phone system.
Account numbers can also be
stored for use.
7-37