Doyon JA6SLG User Manual page 23

Step #3
SP3 appears.
Use the arrows to adjust to the desired temperature
Press on the number of the menu to confirm
t3 appears
Use the arrows to select the desired timing
Press on the number of the menu to confirm
E3 appears
Use the arrows to select the desired code
Press on the number of the menu to confirm
To get out of the programming mode, press #12 and then press "CLOCK" twice (#12, CLOCK,
CLOCK). The screen will show 00:00.
After fulfillment of this program:
• The oven will continue to heat because there was a temperature included in step 3. If the
temperature at that step would have been of 0°F, the oven would have stopped at the end
of the program.
• In this example, the inside buzzer will work 15 seconds while the outside buzzer will start
and will not stop until another program is selected.
• If you want to end a program already running, press the button corresponding to that menu
and then choose a pause menu. If you stop a program that was running without choosing
another menu, it will be paused in the conditions in which it was stopped. Ex: If there is an
interruption during a steam cycle, it will keep running until you choose another menu.
However, there is a 45 seconds limit time for the steam, independent from the Watlow
controller.
A21
Suggested values
(375°F)
(ex. # 2)
(00:15)
(ex. # 2)
(0010 for the buzzer)
(ex. # 2)