Advertisement
Available languages
Available languages
TOOL REQUIRED: SCREWDRIVER AND DRILL
A. CHARGINGISTORAGE BASE
Designed to sit in the charging base on a flat surface (Diagram 1) or mount
vertically (Diagram 2).
For tidy storage, wrap excess cord on the back of the charging base and exit
at either side or out the bottom.
TO WALL MOUNT:
1. Place charging base against the mounting surface. Mark the centers of the holes.
2. Move base, then drill a 3/16 hole through the center of the marks.
3. Push plastic wall anchor into the drilled hole.
4. Be sure marked location is correct before drilling the second hole (adjust if
necessary). Drill second hole and install other wall anchor.
Sits on a flat surface.
5.
Match up holes in storage base to wall anchors and insert screws. Be sure
cord exits from one of the cord slots on the storage base
,
,
6. T~ghten the screws to hold the base flush to the mountlng surface
1
*.
,
jj.j,,
B.
UNlT STORAGE
1. Hold the unit by the handle and push down firmly onto the charging base.
2. Be sure the red charging light is on.
C. CHARGING
NOTE: Use only the charger supplied by the manufacturer to recharge.
IMPORTANT: BEFORE FIRST USE, CHARGE YOUR UNlT FOR AT LEAST 24 HOURS.
Power switch must be in the OFF position.
the charger to become warm to the touch when charging.
Keep the charger plugged into a standard outlet at all times. It is normal for Sits vertically or mounts on
the wall.
If the operating time gets shorter after repeated use, let the unit run until it
stops running. Recharge for 24 hours and repeat monthly for best results.
TO USE: Slide the power switch to the ON position.
TO TURN UNlT OFF: Slide the power switch to the OFF position.
Empty and clean the unit and filter after each use or after large pickups when the unit becomes full.
The crevice tool is permanently stored on board. It is located on the to^ of the dust
CUD
for vour convenience.
.
.
TO USE
TO
STORE
Press the crevice tool
Flip crevice tool down to line
To store crevice tool: Pull
release button.
up with nozzle then press up
down until loose. Flip crevice
until secure in place.
tool up towards unit and you
feel it lock into place.
RETRACTABLE BRISTLES
Ideal for cleaning delicate
surfaces. To use: slide the
switch underneath dirt con-
tainer forward. Slide switch
back to retract bristles.
For filter replacement part # 3-089570-001, please call 1-800-321-1134.
Depress the dirt cup release
Hold nozzle over a waste-
Shake excess dirt and
button and pull nozzle away
basket. Grasp filter and gen-
debris out of dust cup.
from unit.
tly pull out. For filter
Brush the dust and dirt off
replacement call 1-800-
the filter, or shake the filter
321 -1 134.
inside of the wastebasket.
IMPORTANT:
DO
NOT
WASH FILTER.
Advertisement
