Dirt Devil M085580 Owner's Manual page 9

NOTE: U n ~ l u u cleaner before changing belt or brushroll
L
Lay cleaner flat and flip cleaner over to
expose nozzle base. Base should lay flat and
face up. To remove nozzle guard, use a
Phillips Screwdriver to remove the three (3)
screws. Arrows show location of screws.
Push on the two tabs to release. Lines show
location of tabs. Lift nozzle guard off.
Be sure belt is off motor shaft.
Lift and remove brushroll.
Dispose of old belt.
REPLACEMENT
Loop belt onto motorshaft.
Place new belt in area
Insert brushroll into side holder
#I Replace nozzle guard. Match the front
of brushroll without
and then #2. Follow direction of tabs to the slots on the nozzle base first.
bristles.
arrows on brush end caps, (Diagram
Swing down to snap hooks. Press firm-
3a). NOTE: Rotate brushroll to make
ly on entire nozzle guard to Secure.
sure belt is not twisted.
Replace the three (3) screws to secure.
IMPORTANT: ROTATE BRUSHROLL BY
HAND BEFORE STARTING CLEANER
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE SERVICING.
IF OBSTRUCTION DEVELOPS DURING FLOOR CLEANING:
1. If obstruction develops while cleaning carpets, turn cleaner OFF and unplug. Check paper bag to see if it is
full. If full, replace with a new paper bag (Page 8).
2. Check dirt tube to see if there is an obstruction (Page 6, Diagram 4 under heading, "HOSE ASSEMBLY").
If so, remove obstruction.
3. Turn cleaner over and remove nozzle guard (Page 9, Diagram 1). Clear any obstruction that occurs in or
around the brushroll area.
4. Remove hose from hose inlet (Page 6, Diagram 4 under heading, "HOSE ASSEMBLY"). Remove any obstruction.
NOTE: Regularly clean debris from filter in bag compaflment (Page 8).
IF OBSTRUCTION DEVELOPS DURING TOOL USAGE:
1. If obstruction develops while above floor cleaning, turn cleaner OFF and unplug. Check paper bag to see
if it is full. If full, replace with a new paper bag (Page 8).