1
INVERTER INSTALLATION AND PRECAUTIONS
Inverter model
r
FR -
F8 0
6
Symbol Voltage class
Symbol
00680 to 04420 Inverter SLD rated current (A)
6
600 V class
Capacity plate
Inverter model
Serial number
Inverter placement
Installation on the enclosure
Fix six positions for the FR-F860-02890 or higher.
Installation environment
Before installation, confirm that the following environment conditions are met.
Item
FR-F860-00680, 01080
Surrounding air
temperature
FR-F860-01440 or higher
Ambient
95% RH or less (non-condensing)
humidity
Storage
-20 to +65°C
temperature
Atmosphere
Indoors (free from corrosive gas, flammable gas, oil mist, dust and dirt)
Altitude
Maximum 2500 m.
2
Vibration
5.9 m/s
or less at 10 to 55 Hz (directions of X, Y, Z axes)
Temperature applicable for a short time, e.g. in transit.
For the installation at an altitude above 1000 m, consider a 3% reduction in the rated current per 500 m increase in altitude.
2
2.9 m/s
or less for the FR-F860-02890 or higher.
Surrounding air temperature is a temperature measured at a measurement position in an enclosure.
Ambient temperature is a temperature outside an enclosure.
-
00680
- 3
-
60
Description
• Install the inverter on a strong surface securely with screws.
• Leave enough clearances and take cooling measures.
• Avoid places where the inverter is subjected to direct sunlight, high temperature and high humidity.
• Install the inverter on a nonflammable wall surface.
• When encasing multiple inverters, install them in parallel as a cooling measure.
• When designing or building an enclosure for the inverter, carefully consider influencing factors such as heat
generation of the contained devices and the operating environment.
Allow clearance.
For replacing the cooling fan of the FR-F860-02890 or higher, 30 cm of space is necessary in front of the inverter.
Refer to the Instruction Manual (Detailed) for fan replacement.
-10°C to +40°C (non-freezing)
-10°C to +50°C (non-freezing) (LD rating)
-10°C to +40°C (non-freezing) (SLD rating)
Symbol Type
Symbol
(conforming to IEC60721-3-3 3C2/3S2)
3
CA3
60
06
Rating plate
Inverter model
Input rating
Output rating
SERIAL
Country of origin
Clearances (front)
FR-F860-01080 or lower
10 cm
or more
5 cm
or more
Vertical
10 cm
or more
Description
INVERTER INSTALLATION AND PRECAUTIONS
Circuit board coating
Plated
conductor
With
Without
With
With
FR-F860-01440 or higher
20 cm
or more
5 cm
or more
10 cm
10 cm
or more
or more
20 cm
or more
Enclosure
5 cm
Measurement
position
Clearances (side)
5 cm
or more
∗1
Inverter
Measurement
position
Inverter
5 cm
5 cm
5