Image Erase Operation - Konica Minolta REGIUS SIGMA2 Operation Manual

3 .2

Image Erase Operation

Plate images can be erased by performing the
following steps .
CAUTION
• Make sure not to pinch your fingers while inserting the
cassette .
HINT
• If only performing the image erase process, the Image
processing controller does not have to be started up .
1
Prepare a cassette with an image erasing
plate loaded .
If there is a memo between the cassette's memo
clip, remove it . If there is a sticker etc . attached to
the cassette, remove it .
CAUTION
• Only cassettes specially made for this device can be
used .
2
Confirm that the Image processing con-
troller is not in image capture standby
mode (that the CR "Modality" button has
not been clicked) .
REFERENCE
• For details, refer to the Image processing controller
Operation Manual .
3
Confirm that the device's Ready Lamp
(green) is lit .
4
Hold down the erase button for at least 2
seconds .
• The device will go into Image Erase Mode, and
the Erase Lamp (orange) will start blinking .
Erase Lamp
Erase Button
HINT
• The Erase Lamp will be lit while pressing the erase
button .
• In order to prevent operational errors from occurring, if
the cassette is not inserted within 5 seconds from the
beginning of Image Erase Mode, the device will return
to Image Read Mode .
5
Insert the cassette in the cassette inser-
tion slot .
CAUTION
• Do not insert anything other than the cassette in the
cassette insertion slot . Doing so may cause a malfunc-
tion .
If a foreign object has fallen inside of the device, con-
tact Konica Minolta technical representatives .
Position the back side of the cassette facing up-
ward, and slowly slide it into place, straight and all
the way to the back, in the direction of the arrow .
• The image erase process will begin .
• The Erase Lamp (orange) is lit while images are
being erased .
HINT
• If the cassette was inserted before pressing the erase
button, holding down the erase button for at least 5
seconds will start up the image erase process .
30
Insert so that
center-sections
match.