Required Tools And Materials; Decommissioning And Disposal; Cabling Recommendations - Siemens SIMATIC NET RUGGEDCOM RX1512 Installation Manual

1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RX1512:
AC/DC power cord (16 AWG)
Lightning protector
Shielded coaxial cables
SIM Card(s) provided by the network carrier
Flathead screwdriver
Phillips screwdriver
4 x #6-32 screws
Braided or equivalent ground wire
1.4

Decommissioning and Disposal

Proper decommissioning and disposal of this device is important to prevent malicious
users from obtaining proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of
service, either permanently or for maintenance by a third-party, make sure it has
been fully decommissioned.
For more information, refer to the associated Configuration Manual.
Recycling and Disposal
For environmentally friendly recycling and disposal of this device and related
accessories, contact a facility certified to dispose of waste electrical and electronic
equipment. Recycling and disposal must be done in accordance with local
regulations.
1.5

Cabling Recommendations

Siemens recommends using SIMATIC NET industrial Ethernet shielded cables for all
Ethernet ports.
RUGGEDCOM RX1512
Installation Manual, 04/2021, C79000-G8976-1057-20
information, refer to
17)".
Tools/Materials
1.3 Required Tools and Materials
"Accessing the CompactFlash Card (Page
Purpose
For connecting power to the device.
For protecting the device from harmful electrical
strikes.
For connecting the device to antennas and an
Ethernet network.
For accessing a network carrier's cellular network.
Required only if a cellular modem module is
equipped.
For mounting the device to a DIN rail.
For mounting the device to a panel.
For mounting the device to a panel.
For grounding the device to safety Earth.
Introduction
3