To Install The Blade; Operation - DeWalt DC300 Instruction Manual

36v cordless circular saw
Hide thumbs Also See for DC300:
Table of Contents

Advertisement

Available languages

Available languages

Installing and Removing the
Battery Pack (Fig. 2, 3)
NOTE: Make sure your battery pack is fully charged.
CAUTION: Make certain the switch lock-off button (A) is
engaged to prevent switch actuation before removing or installing
battery.
To install the battery pack into the tool handle, align the base of
the tool with the rails inside the tool's handle and slide the battery
pack firmly into the handle until you hear the lock snap into place.
To remove the battery pack from the tool, press the release
button (N) and firmly pull the battery pack out of the tool handle.
Insert it into the charger as described in the charger section of this
manual.
FIG. 2
N

OPERATION

Switch
Release switch lock-off button (A) by pressing button as shown
(Fig. 3). Pull the trigger switch (B) to turn the motor ON. Releasing
the trigger switch turns the motor OFF. Releasing the trigger
switch also automatically actuates lock-off button.
FIG. 3
A
B
10
NOTE: This tool has no provision to lock the switch in the ON
position, and should never be locked ON by any other means.
Changing Blades
CAUTION: TURN OFF TOOL AND REMOVE BATTERY PACK
FROM SAW BEFORE CHANGING ACCESSORIES OR MAKING
ANY ADJUSTMENTS.
This tool is equipped with a keyless blade clamp (H) and is
designed to be tightened by hand. The use of external tools may
cause damage to this blade clamp.

TO INSTALL THE BLADE

1. Place inner clamp washer (O) on saw spindle with the large flat
surface facing out toward the blade (Fig. 4).
2. Retract the lower blade guard (G) and place blade on saw spin-
dle against the inner clamp washer, making sure that the blade
will rotate in the proper direction (the direction of the rotation
arrow on the saw blade and the teeth must point in the same
direction as the direction of rotation arrow on the lower guard).
Do not assume that the printing on the blade will always be fac-
ing you when properly installed. When retracting the lower blade
guard to install the blade, check the condition and operation of
the lower blade guard to assure that it is working properly. Make
sure it moves freely and does not touch the blade or any other
part, in all angles and depths of cut.
3. Place outer clamp washer (P) on saw spindle with the large flat
surface against the blade and the side with ratchet teeth facing
out.
4. Thread the keyless blade clamp (H) into saw spindle by hand
(clamp has left-hand threads and must be turned counterclock-
wise to tighten).

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents