Installation / Setup - Buffalo AirStation WBR2-G54S User Manual

Follow these simple steps to connect the AirStation to your Broadband Internet connection allowing
you to combine and share wired and wireless computers and printers with the high-speed internet
connection.
4. Power on your cable or DSL modem, wait one full minute, Power on the AirStation router, wait
another full minute and then power on the computer which will be used to confi gure the AirSta-
tion. If the red DIAG light on the AirStation is lit or fl ashing after several minutes of being pow-
ered on, please consult Buffalo Technical Support.

Installation / Setup

1. Power down the Cable or DSL modem and
the computer which will be used to confi gure the
AirStation router.
2. Plug the Cable or DSL's LAN Ethernet cable into
the AirStation's WAN port. Initially, you may need
to unplug this cable from your computer, hub or
other router.
3. Plug the provided Ethernet cable into a LAN
port on the AirStation and plug the other end into
your computer Ethernet adapter's (NIC) port. If
you plan to initially confi gure the AirStation via a
wireless connection, (not recommended), you may
skip this step.
11