Installation/Setup; Hardware Installation - Buffalo AirStation WBR-G54 User Manual

2
bine and share wired and wireless computers and printers with the high-speed internet connection.
1. Power down the cable or DSL modem and the computer which will be used to configure the AirStation router.
2. Plug the cable or DSL's LAN Ethernet cable into the AirStation's WAN port. Initially, you may need to unplug this cable
3. Plug the provided Ethernet cable into a LAN port on the AirStation and plug the other end into your computer
4. Power on your cable or DSL modem, wait one full minute, Power on the AirStation router, wait another full minute and
7
WBR-G54 User Manual

Installation/Setup

from your computer, hub or other router.
Ethernet adapter's (NIC) port. If you plan to initially configure the AirStation via a wireless connection, (not recom-
mended), you may skip this step.
then power on the computer which will be used to configure the AirStation. If the red DIAG light on the AirStation
is lit or flashing after several minutes of being powered on, please consult Buffalo Technical Support.