Buffalo AirStation WBR2-G54 User Manual page 25

Now that the WBR2-G54 and wireless client adapter are
◗
installed, you can use AOSS to configure them.
To begin the configuration, press the AOSS button on
◗
the back of the WBR2-G54 for 3-5 seconds. The AOSS
light will begin to flash when the AOSS mode has been
enabled. You can stop pressing the button at this point.
■ NOTE: AOSS mode will stay active for a period of
two minutes. This is the time-slot required to initiate the
wireless client adapter. The AOSS LED will stop flashing
when AOSS mode has stopped or timed out.
Refer to your wireless client adapter's AOSS
◗
supplement to initiate the wireless client adapter's AOSS
mode.
It typically takes 10-15 seconds for the AOSS light to
◗
stop flashing after the AOSS button has been pressed
on the wireless client adapter. Once configuration is
complete, the AOSS light will remain steady. Please
refer to your wireless client adapter's supplement for the
remainder of the setup.
25
AOSS